How to Resolve HP Printer Alignment Failed Problem
You have purchased a new HP printer and plan to configure it along with your system. When you start printing, suddenly an error appears on the screen HP Printer Error 0xc18a0206.
The question will keep you upset and stressed after seeing this specific error message. Don’t worry; here are some troubleshooting steps to correct this misalignment. There can be many reasons for this HP printer distress error. To get rid of these problems immediately, you should call the HP printer customer service number, and also a technical executive will take very good care of this matter and offer you immediate solutions to eliminate it.
What is the meaning of ‘Alignment failed’ on the HP printer?
In short, misalignment cannot get ink into the capsules. There can be countless reasons ranging from software to hardware malfunction. On this site, you will study the preventive measures to eliminate this nasty mistake. Let’s go through all these troubleshooting steps one by one.
What are the hints and tips to eliminate misalignment errors on HP printers?
Restart your printer
It is necessary to restart the printer using rigorous procedures in a couple of cases, as it can be properly aligned by restarting it. The practice of restarting the printer is simple. Turn off the printer for 10 minutes or more and turn it on again if you are unfamiliar with the reset steps.
You will hear a buzzing sound once you restart your printer, and it will align the ink and cartridges correctly along with the printer. If the problem still appears on the screen, you should proceed to the next troubleshooting step to fix it.
Remove the plastic tape from the ink cartridges
For starters, you start looking for HP’s how-to guide for understanding how to use an HP printer but have forgotten to remove the ink cartridges wrapped in vinyl tape that covers the ink feed site.
Follow the quick check by turning off the printer and removing the capsules and see if there is vinyl tape covering it. Keep the ink and toner holes constantly open, as no debris will get in and stick there to clog the ink. Reinsert the capsules over and over again and then try printing the projects again.
Insert the ink cartridges properly
If the ink cartridges are not inserted correctly, you will not get a great print. The cartridges need to be pushed to fit, and if not, don’t expect the cartridges to continue inside the printer. Check the instruction guide for adding capsules
· Turn off the printer and make sure the cartridges are installed in order.
· Later, change it.
· Try to push the capsules round when the printer is held facing the hard side.
You have done everything possible to eliminate the misalignment of the HP printer; however, you are still frustrated that the alternatives did not give you enough help to eliminate the HP Printer not Responding error. The HP printer misalignment problem can be resolved through a technical advisor who will direct you to take some important actions to clear this error immediately.
